BRACKET 3556585 - Caterpillar

22. Fasten a hoist to the output gear assembly (29). Remove pipe (17), plate (18) and bolt that hold gear assembly in place. Remove output gear assembly (29). Weight of the assembly is 145 lb. (65 kg). 23. Install tooling (E) and remove the bearing cone and spacer (30) from the shaft. 24. Install tooling (F) and remove gear (31), spacer and bearing cone from the shaft. 25. Fasten a hoist to the lower gear assembly (32). Remove the wire that holds the gear assembly in place. Remove gear assembly (32). Weight of the assembly is 65 lb. (29 kg). 26. Install tooling (D) and remove the bearing cones from gear assembly (32). 27. Install a 5/8"-11 NC forged eyebolt in output gear cage (33) and fasten a hoist. Remove the bolts that hold cover to housing.28. Install two 5/8"-11 NC forcing screws (34) in cover and remove cage (33). Weight of the cover is 65 lb. (29 kg).29. Remove bearing cup from cage with tooling (G).30. Remove the O-ring seal and shims from cage (33).Install Final Drives
1. Lower the temperature of the bearing cup for cage (1) and install it in the cage. Install two 5/8"-11 NC guide bolts (2) in the housing. Fasten a hoist to the cage and put it in position on the housing without shims or the O-ring seal.2. Install three bolts approximately 120° apart. Tighten the bolts until there is 1/4 in. (6.35 mm) distance between the cover and housing. 3. Heat bearing cones (3) and (5) in oil to a maximum temperature of 275°F (135°C). Install the bearing cones on gear assembly (4). 4. Fasten a hoist to gear assembly (4) and put it in position in the housing. Use same procedure to hold gear assembly in place as was used in REMOVE FINAL DRIVES. 5. Install spacer (7) on shaft (6). Put 2P2506 Anti-Seize Compound on the shaft and gear splines. Put gear (8) in position on the end of the shaft. Install tooling (A) and push the gear into position with a force of 25 + 20 - 15 ton (225 + 180 - 135 Kn). 6. Install spacer (9) on the shaft.7. Heat bearing cone (10) to a maximum temperature of 275°F (135°C). Install the cone on the shaft. 8. Heat bearing cone (11) in oil to a maximum temperature of 275°F (135°C). Install the cone on the shaft.9. Install spacers on the shaft. 10. Fasten a hoist to the output gear assembly (12) and put it in position in the housing. Use the piece of pipe, plate and bolt to hold the gear assembly in place. 11. Heat bearing cones (13) and (15) to a maximum temperature of 275°F (135°C). Install the cones on gear (14). 12. Install gear assembly (16) in the housing. Install the wire that holds gear assembly in place. 13. Lower the temperature of bearing (17) and install the bearing in rear cover. 14. Install retainer (19) and the bolts (18) that hold