BRACKET AS 3904692 - Caterpillar

2. Remove nine screws (1) and remove rear cover (2). 3. Remove four hoses (3) from the steering control unit. Cap or plug the hoses and fittings, immediately. 4. Cut wire ties (4) from the electrical harness. 5. Remove bolt (5) from harness clamp (6).6. Remove four bolts (7) from harness clamp and remove clamp. 7. Loosen two screws (8) on the differential lock switch to disconnect the two wires. 8. Disconnect electrical connector (9). 9. Remove two screws (10) from the breaker panel and let the panel hinge down. 10. Disconnect two wires (11) from the breaker panel. 11. Disconnect three electrical connectors (12) that plug into the bottom of the console. 12. Disconnect two hoses (13) from the rotor bleed down valve. Cap or plug hoses and fittings, immediately. 13. Disconnect three hoses (14) from the brake valve Cap or plug the hoses and fittings, immediately. 14. On the left side, remove three bolts (15) from the underside of the console. 15. Remove three bolts (16) from the right side of the console. 16. Attach a strap and suitable lifting device to lifting eye (17) on top of the console.17. Slowly lift the console, making sure all the hoses and electrical cables are clear, then remove the console from the machine.18. For installation of the operators console, reverse the removal steps.19. Connect the batteries.