AVSPARE.COM
parts catalog

BRACKET AS 3966949 - Caterpillar



3966949 BRACKET AS Caterpillar parts BRACKET
Rating:
46
Alternative (cross code) number:
CA3966949
396-6949
3966949
Caterpillar 3966949 BRACKET AS

Buy BRACKET AS 3966949 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 1
  
  For full view, you need register

Information:

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
1/2 inch - UNF by 4 inch 2
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g02062093
Always wear protective gloves when handling parts that have been heated.
If the flywheel ring gear was removed, follow Step 1.a through Step 1.c in order to install ring gear (3) to flywheel (1).
Identify the orientation of teeth (4) on new ring gear (3). Note: The chamfered side of ring gear teeth (4) must face toward the starting motor when the flywheel is installed. The chamfered side of ring gear teeth ensures the correct engagement of the starting motor.
Heat flywheel ring gear (3) in an oven to a maximum temperature of 250 °C (482 °F) prior to installation. Note: Do not use a torch to heat the ring gear.
Ensure that the orientation of ring gear (3) is correct and quickly install the ring gear onto flywheel (1).
Inspect the crankshaft rear seal for leaks. If there are any oil leaks, replace the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Install" for the correct procedure.
Illustration 2 g02062053
Install a suitable lifting device on flywheel (1). The flywheel can weigh 55 kg (121 lb).
Install Tooling (A) in Position (X) on the crankshaft.
Use the lifting device to position flywheel (1) onto Tooling (A).
Install bolts (2) to flywheel (1).
Remove Tooling (A) and install remaining bolts (2) to flywheel (1).
Use a suitable tool to prevent the flywheel from rotating. Tighten bolts (2) and (4) to a torque of 140 N m (103 lb ft).
Remove the lifting device from flywheel (1).
Check the run out of the flywheel. Refer to System Operation, Testing and Adjusting, "Flywheel" for more information. End By:
Install the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install" for the correct procedure.

Caterpillar parts catalog:

Caterpillar parts catalog
C4.4 DE65E3, DE88E0, DE88E3, DE110E3, DE110E2 Generator Set GT800001-UP
C4.4 DE65E3, DE88E0, DE88E3, DE110E3, DE110E2 Generator Set EC800001-UP


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.