3C8278 BRACKET Caterpillar parts
Rating:
Alternative (cross code) number:
CA3C8278
3C-8278
3C8278
CA3C8278
3C-8278
3C8278
Weight: 0.010 pounds 0 kg.
For full view, you need register
Information:
Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 5P-9722 Seal Driver 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01182768
Use a suitable press to install the shaft and the bearing into pulley (4). Install the shaft until the shaft is flush with the end of pulley (4) .
Use a suitable press to install the shaft, the bearing, and pulley (4) as a unit into water pump housing (3). The distance between the front of pulley (4) and the machined surface of water pump housing (3) must be 103.8 0.3 mm (4.09 0.01 inch).
Use Tooling (B) to install seal (5) in water pump housing (3) .
Use a suitable press to install impeller (2) on the shaft of the water pump. Install the impeller until the distance between the impeller and the machined surface of the water pump is 0.75 0.25 mm (0.030 0.010 inch).
Illustration 2 g01026865
Install a new gasket and cover (1) .End By: Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".
Table 1
Required Tools
Tool Part Number Part Description Qty
B 5P-9722 Seal Driver 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01182768
Use a suitable press to install the shaft and the bearing into pulley (4). Install the shaft until the shaft is flush with the end of pulley (4) .
Use a suitable press to install the shaft, the bearing, and pulley (4) as a unit into water pump housing (3). The distance between the front of pulley (4) and the machined surface of water pump housing (3) must be 103.8 0.3 mm (4.09 0.01 inch).
Use Tooling (B) to install seal (5) in water pump housing (3) .
Use a suitable press to install impeller (2) on the shaft of the water pump. Install the impeller until the distance between the impeller and the machined surface of the water pump is 0.75 0.25 mm (0.030 0.010 inch).
Illustration 2 g01026865
Install a new gasket and cover (1) .End By: Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".