BRACKET 3N3694 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.An authorized operator may perform the maintenance items with daily intervals. An authorized operator may perform the maintenance items with intervals of every week. The maintenance that is recommended for all other maintenance intervals must be performed by an authorized service technician or by your Cat dealer.The user is responsible for the performance of all maintenance which includes the following items: performing all adjustments , using proper lubricants, fluids, and filters and replacing old components with new components due to normal wear and aging .Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Choose the interval that occurs first in order to determine the correct maintenance interval: fuel consumption , service hours and calendar time . Products that operate in severe operating conditions may require more frequent maintenance. All of the following will affect the oil change interval: operating conditions , fuel type , oil type and size of the oil sump . Scheduled oil sampling analyzes used oil in order to determine if the oil change interval is suitable for your specific engine. Refer to this Operation and Maintenance Manual , "Engine Oil and Filter - Change" in order to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual , "Maintenance Recommendations" .Unless other instructions are provided, perform maintenance and perform repairs under the following conditions:The starting system is disabled.The engine is stopped.The generator does not pose an electrical shock hazard.The generator is disconnected from the load.When Required
Air Prelube Pump Lubricator Bowl - Clean
Battery - Recycle
Battery or Battery Cable - Disconnect
Fuel System - Prime
Generator - Dry
Generator Set - Test
Rotating Rectifier - Test
Varistor - Test
Winding - Test
Zinc Rods - Inspect/Replace
Every Week
Air Prelube Pump Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Annunciator Panel - Inspect
Battery Charger - Check
Battery Electrolyte Level - Check
Bearing Temperature - Measure/Record
Cooling System Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Clean
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Space Heater - Check
Standby Generator Set Maintenance Recommendations
Stator Winding Temperature - Measure/Record
Voltage and Frequency - Check
Walk-Around Inspection
Every 6 Months
Cooling System Coolant Sample (Level 1) - Obtain
Every 2000 Service Hours or 6 Months
Generator Set Vibration - Inspect
Every