BRACKET 4270609 - Caterpillar

Illustration 7 g01155395
Install block (9) to the left side in the area for the grease pump. Connect pressure sensor (12) and hose (10) .
Turn connector (21) that is shown in Illustration 7.
Download electronic software (19) to the ECM for the machine monitor. Download electronic software (20) to the ECM for the machine.
Purge the air from the grease lines by starting the grease pump in manual mode.Installation of the Autolube Pressure Sensor on the 385B and 385B L Machines
Table 5
Required Parts for the 385B and 385B L Machines    
Item    Part Number    Description    Qty    
1     7K-1181     Cable Strap     16    
2     3S-2093     Cable Strap     21    
3     116-0118     Clip     1    
4     259-4946     Control Harness As     1    
5     259-4947     Sensor Harness As     1    
6     259-4948     Sensor Harness As     1    
7     108-6709     Connector As     3    
8     149-6586     Hose As     1    
9     245-5595     Block     1    
10     245-5596     Hose As     1    
11     245-5647     Plate As     1    
12     247-5201     Pressure Sensor     1    
13     5P-1076     Hard Washer     2    
14     8T-4139     Bolt     1    
15     8T-4194     Bolt     1    
16     257-4540     Nut     1    
17     257-4541     Sleeve     1    
18     247-5159     Monitor Software Gp     1    
19     260-2116     Machine Software Gp     1    
Turn the disconnect switch to the OFF position. Open the cover to the relay panel.
Remove the connector for the timer relay. Install harness (4) to the timer relay.
Illustration 8 g01155471
Connect other connectors on harness (4) to harness (5). Harness (5) should be connected to J1-P60 of the machine controller and to ground.
Illustration 9 g01155473
Route harness (5) around the step in the engine area along the left side of the upper frame.
Connect harness (5) with harness (6). Route harness (6) to the area for the grease pump.
Illustration 10 g01155475
Connect harness (6) with pressure sensor (12) in the area for the grease pump.
Illustration 11 g01155478
Install block (9) to the left side in the area for the grease pump. Connect pressure sensor (12) and hose (10) .
Download electronic software (18) to the ECM for the machine monitor. Download electronic software (19) to the ECM for the machine.
Purge the air from the grease lines by starting the grease pump in manual mode.