BRACKET 4310056 - Caterpillar

Illustration 4 g00989871
Install bolt (11) and the washer in order to secure pin (10) in position.
Illustration 5 g00987257
Typical example
Install suitable cribbing on both sides of the machine between the chassis and the axle.
Illustration 6 g00989865
Remove Tooling (C) and the attached lifting equipment from the axle.
Illustration 7 g00987114
Attach a suitable nylon lifting sling around wheel (9). Attach the nylon lifting sling to a suitable hoist in order to support the wheel. The weight of the wheel without ballast is approximately 190 kg (420 lb).Note: Liquid ballast is installed in the tires of certain machines. Liquid ballast will greatly increase the weight of a wheel. You must be sure that the weight of the wheel will not exceed the lifting capacity of your lifting equipment. Refer to Operation and Maintenance Manual, "Tire Inflation Information" for additional information about the recommended weight of installed liquid ballast.
Illustration 8 g00987111
Position wheel (9) to the machine before installing wheel nuts (8) and the spring washers. Do not tighten the nuts at this step.
Remove the nylon lifting sling and the hoist from wheel (9) .
Repeat Step 10 to Step 12 for the wheel on the other end of the axle.
Illustration 9 g00989518
Left side of the machine
Illustration 10 g00987112
Right side of the machine
Position Tooling (A) under the machine and use the Tooling to raise the machine off Tooling (B) .
Remove Tooling (B) from the machine.
Illustration 11 g00987108
Use Tooling (A) to lower the machine onto the ground before removing the Tooling from the machine.
Illustration 12 g00987107
Tighten wheel nuts (8) in a cross pattern to a torque of 240 40 N m (177 30 lb ft) and then turn an additional 60 degrees 5 degrees. Note: Check the wheel nut torque on new wheels and on repaired wheels after every ten service hours until the specified torque is maintained. Refer to Operation and Maintenance Manual, "Wheel Nut Torque - Check".
Repeat the Step 17 on the wheel nuts on the other end of the axle.
Illustration 13 g00987259
Position the rod eye of cylinder (4) to bracket (7) before installing pin (5). Install bolt (6), the washer and the spacer that secures the pin to the bracket.
Illustration 14 g00987478
Connect electrical connector (2) for the sensor on the steering cylinder. Connect hoses (3) to the steering cylinder.
Illustration 15 g00987479
Connect electrical connector (1) for the level sensor on the axle.
Illustration 16 g00987257
Remove the cribbing that was installed between the chassis and the axle in Step 8., End By: Install the fenders to the axle. Refer to Disassembly and Assembly ManualRENR5192"Machine Systems", "Fender - Remove and Install".