BRACKET 4540117 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     256-4866
or
256-4871     Seal Installer     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
If the front housing is not installed, do not turn the crankshaft. Damage to the engine may occur.
Clean all surfaces thoroughly. Inspect the condition of the gasket. Replace the gasket, if necessary.
Install Tooling (A) on the crankshaft.
Illustration 1 g01041799
When front housing (3) is installed, rotate mechanical stop lever (2) in a clockwise direction for easier installation. Observe the position of the linkage (not shown) in the front housing. In order for the link to be connected during the fuel injection pump installation, correctly position the link for the fuel injection pump.
Align locating pin (5) with locating hole (4) on the oil pump cover.
Position front housing (3) on the front of cylinder block (1) .
Install bolts (7) and nuts (6) finger tight. Tighten bolts (7) and nuts (6) to a torque of 10 N m (89 lb in).
Remove Tooling (A) from the crankshaft.Note: Do not adjust the maximum fuel adjustment screw if the front housing or the governor linkage have been replaced. You must check the high idle rpm after assembly of the front housing.End By:
Install the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
Install the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Install".