BRACKET AS 4860973 - Caterpillar

Assembly
Group A, C, and, D
Illustration 1 g02797074
(AE) For use with 834H, 836H, and 988H
Start the installation by deciding whether to use bracket (5) or bracket (23). Bracket (5) is shown in view A-A and bracket (23) is shown in bracket view (AE) .Note: Bracket (5) is for use with 824H, 825H and 826H. Bracket is for use with 834H, 836H, and 988H.
Attach camera group (4) and grommet (6) to the proper bracket (5) or (23).
Attach proper bracket (5) or (23) to the frame using bolt (7) and proper washer (8) or (22) .Note:
Illustration 2 g02759136
(BE) cable connector with pins (BF) cable connector with sockets
Use Illustration 1 to route cable assembly (1) and cable assembly (3). Use cable straps (31 ) as required. Join cable assemblies (1) and (3) with connectors (BE) and (BF) .Group B
Illustration 3 g02797266
(BA) Strap to weld links or main cab harness (BB) Strap to main cab harness (BC) Route the harness from the inside connection on the rear sheet assembly. Then route through the hole on the rear right side of the floor assembly. Follow the main cab harness routing on the bottom of the floor assembly up the right side of the hole in the floor. Continue up the right-hand B-Post and towards the front of the cab along the inside of the roof. (BD) Strap to the main cab harness (MA) Detail of bolt (9), boss (10), washer (11), bolt (14), washer (15), nut (16), clip (12), cable strap (13), clip (19), and camera display group (19)
Illustration 4 g02794579
Monitor orientation for the 824H, 825H and 826H
Illustration 5 g02795967
Monitor orientation for the 834H, 836H, and 988H
Remove the mirror assembly. Attach bracket (18) using existing hardware. Use bolt (9), washer (11), boss (10) along with bolt (14), washer (15), and nut (16) to complete attachment of the camera display group (19), detail (MA). Note: Detail (MA) is the same for all machines listed in this Special Instruction
Secure camera display group (19) using the proper orientation for your machine.
Install connector group (20) using the proper orientation for your machine.
Use Illustration 3 to route cable assembly (21) and secure the cable with clips (12), (17) and cable strap (13) .