BRACKET 4V6571 - Caterpillar

Illustration 1 g02000895
The location of the parking brake (1) on the operator console
Push down on the upper part of the parking brake switch (1) in order to engage the parking brake.
Illustration 2 g01161211
The location of the propel speed lever on the operator side console
Move the propel speed lever to the NEUTRAL position.
Verify that all of the switches on the operator console are in the OFF position.
Verify that all of the switches on the operator side console are in the OFF position.
Illustration 3 g02000913
(2) Engine throttle control (3) Engine start switch (4) Display panel (5) Horn
Move the engine throttle control (2) to the LOW IDLE position.
Turn the engine start switch (3) to the ON position. Observe the display panel (4) for error messages. Correct any faults.
Sound the horn (5) twice. Wait for several seconds to alert nearby personnel.
Turn the engine start switch (3) to the START position. Release the engine start switch (3) when the engine starts. If the engine does not start after 30 seconds, release the switch. Allow the starter to cool for two minutes before cranking again.Note: Do not engage the starter until the starter motor and the flywheel have stopped rotating.
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result if the engine rpm is not kept low until the oil gauge display verifies that the oil pressure is sufficient.
Illustration 4 g01208438
The location of the rotor service switch (6)
Illustration 5 g01208442
(7) SERVICE positionNote: The engine will not start if the rotor service switch (6) is in the SERVICE position (7) .You should use starting aids for cold weather starting if the temperature is below −18 °C (−0 °F). A heater for the coolant may be required for cold weather starting. A heater for the fuel may be required for cold weather starting. A jacket for the water may be required for cold weather starting. More capacity for the battery may be required for cold weather starting.At temperatures below −23 °C (−10 °F), you should consult your Caterpillar dealer. You can use Special Publication, SEBU5898 for the recommended starting procedure. The Operation and Maintenance Manual is available at your Caterpillar dealer.