AVSPARE.COM
parts catalog

BRACKET AS 5089139 - Caterpillar



5089139 BRACKET AS Caterpillar parts BRACKET
Rating:
46
Alternative (cross code) number:
CA5089139
508-9139
5089139
Caterpillar 5089139 BRACKET AS
Weight: 0.51 pounds 0 kg.

Buy BRACKET AS 5089139 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 10
 
  For full view, you need register

Information:

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, on wires and on all tube assemblies for installation purposes. Plug all hose assemblies and tube assemblies. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01318612
Typical example
Turn the fuel supply to the OFF position.
Turn the battery disconnect switch to the OFF position.
Disconnect plastic tube assemblies (4) and (5) from fuel priming pump (3).
Disconnect plastic tube assemblies (4) and (5) from fuel priming pump (3).
Disconnect plastic tube assembly (2) from fuel priming pump (3).
Plug all the connections on fuel priming pump (3) and plastic tube assemblies (4) and (5).
Disconnect the harness assembly from fuel priming pump (3).
Support the fuel priming pump. Remove bolts and washers (1) and remove fuel priming pump (3). Note: Note the location and the orientation of the brackets for the tube assemblies.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01318612
Typical example
Ensure that the fuel priming pump is clean and free from wear or damage. If necessary, replace the fuel priming pump as a complete assembly.
Position fuel priming pump (3) onto the cylinder head. Install bolts and washers (1). Ensure that any brackets that are retained by the bolts are installed in the correct position. Tighten the bolts to a torque on 9 N m (80 lb in).
Remove all plugs from the fuel priming pump and from the plastic tube assemblies. Connect plastic tube assemblies (4) and (5) to fuel priming pump (3).
Connect plastic tube assembly (2) to fuel priming pump (3).
Install the harness assembly to fuel priming pump (3).
Turn the fuel supply to the ON position.
Turn the battery disconnect switch to the ON position.
Remove the air from the fuel system. Refer to Operations and Maintenance Manual, "Fuel System - Prime".

Caterpillar parts catalog:

Caterpillar parts catalog
C175–16 Locomotive Engine 3B900001-UP


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.