AVSPARE.COM
parts catalog

BRACKET AS 5089145 - Caterpillar



5089145 BRACKET AS Caterpillar parts BRACKET
Rating:
76
Alternative (cross code) number:
CA5089145
508-9145
5089145
Caterpillar 5089145 BRACKET AS
Weight: 1 pounds 0 kg.

Buy BRACKET AS 5089145 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 15
 
  For full view, you need register

Information:

Removal Procedure
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Note: Cleanliness is a critical factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned.Note: Put identification marks on all hoses and on all hose assemblies for installation purposes. Plug all hose assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Turn the fuel supply to the OFF position.
Illustration 1 g01382922
Remove bolts (2) and (3) .
Remove fuel priming pump (1) and remove gasket (4) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 2 g01382922
Clean the surfaces that contact gasket (4). Install new gasket (4) .
Position fuel priming pump (1) .
Install bolts (2) and (3). Tighten bolt (2) to a torque of 10 1 N m (89 9 lb in). Tighten bolt (3) to a torque of 17 2 N m (150 18 lb in).
Turn the fuel supply to the ON position.

Caterpillar parts catalog:

Caterpillar parts catalog
C175–16 Locomotive Engine 3B900001-UP


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.