AVSPARE.COM
parts catalog

BRACKET AS 5089146 - Caterpillar



5089146 BRACKET AS Caterpillar parts BRACKET
Rating:
81
Alternative (cross code) number:
CA5089146
508-9146
5089146
Caterpillar 5089146 BRACKET AS
Weight: 1 pounds 0 kg.

Buy BRACKET AS 5089146 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 16
 
  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     185-3630     Strap Wrench As     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hoses, on all hose assemblies, and on all harness assemblies for installation purposes. Plug all hose assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Illustration 1 g01382995
Remove bolts (1) and discard washers.
Remove bolt (3) .
Disconnect harness assemblies (2) and (4) .
Use Tooling (A) in order to remove fuel filter (5) from fuel filter base (6). Refer to Operation and Maintenance Manual, "Fuel System Secondary Filter - Replace".
Illustration 2 g01383017
Remove bolts (7) and remove fuel filter base (6) .Installation Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 3 g01383017
Position fuel filter base (6) and install bolts (7). Tighten bolts (7) to a torque of 32 3 N m (24 2 lb ft).
Illustration 4 g01382995
Install fuel filter (5). Refer to Operation and Maintenance Manual, "Fuel System Secondary Filter - Replace".
Install bolts (1) and install new washers. Tighten bolts (1) to a torque of 34 4 N m (25 3 lb ft).
Install bolt (3). Tighten bolt (3) to a torque of 8.8 1 N m (78 9 lb in).
Connect harness assemblies (2) and (4) .

Caterpillar parts catalog:

Caterpillar parts catalog
C175–16 Locomotive Engine 3B900001-UP


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.