AVSPARE.COM
parts catalog

BRACKET AS 5089153 - Caterpillar



5089153 BRACKET AS Caterpillar parts BRACKET
Rating:
86
Alternative (cross code) number:
CA5089153
508-9153
5089153
Caterpillar 5089153 BRACKET AS
Weight: 0.08 pounds 0 kg.

Buy BRACKET AS 5089153 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 16
 
  For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     278-4138     Fuel System Protection Gp (1)     1    
( 1 ) This tool can only be used one time.
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Note: Cleanliness is an important factor. Before you begin the removal procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all hoses, on all hose assemblies, on all harness assemblies, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.Note: Before opening the fuel system, the engine must be turned off for at least one minute.Note: Use Caterpillar Electronic Technician (ET) to verify that the fuel system pressure is at zero before opening the fuel system.Note: Use Tooling (A) after any fuel line has been disconnected.
Illustration 1 g01383340
Disconnect hose assembly (1) .
Remove nut (4) .
Disconnect hose assemblies (5) and remove the washers. Discard the washers.
Remove bolts (6) and remove bracket (7) .
Remove bolts (3) and remove fuel transfer pump (2) .
Illustration 2 g01383383
Remove seal (8) from fuel transfer pump (2) .

Caterpillar parts catalog:

Caterpillar parts catalog
C175–16 Locomotive Engine 3B900001-UP


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.