BRACKET 5178327 - Caterpillar

Personal injury can result from rotating and moving parts. Stay clear of all rotating and moving parts.Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.The machine must be parked on a level surface and the engine stopped.Attach a "Do Not Operate" or similar warning tag to the start switch and controls before servicing, repairing, or making adjustments to the machine.
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Personal injury or death can occur from heavy components falling during removal or installation.Properly support the component with a suitable lifting device during removal or installation.
Drive the machine to a smooth, horizontal surface.
Illustration 1 g01534584
Move propel lever (1) to the NEUTRAL position.
Rotate propel speed dial (2) to the MINIMUM position.
Move travel mode switch (3) to the PAVE position.
Move parking brake switch (4) to the ON position.
Illustration 2 g01538233
Move screed lift switch (5) to the RAISE position. Completely lift the screed.
Illustration 3 g01534615
Engage screed lock mechanism (6) on both sides of the machine.
Move screed lift switch (5) to the FLOAT position. Allow the tow arms to rest on the screed locks.
Move screed lift switch (5) to the HOLD position.
Illustration 4 g01549314
Move throttle control switch (7) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (8) to the OFF position.
Remove the rear wheel. Refer to Disassembly and Assembly, KENR6411, "Wheel (Rear) - Remove and Install".
Illustration 5 g01549333
The motor is removed from the machine.
Remove bolt (10) from speed sensor (9) .
Install new speed sensor (9) into the motor housing. The design of the sensor will maintain the required gap between the end of the sensor and the speed ring.
Hold speed sensor (9), and tighten bolt (10) .
Install the rear wheel. Refer to Disassembly and Assembly, KENR6411, "Wheel (Rear) - Remove and Install"
Recalibrate the initial current setting to the electronic control module (ECM) for the pump. For the calibration procedure, refer to Specifications, Systems Operation, Testing and Adjusting, "Forward Currents (EDC) - Calibrate" and refer to Specifications, Systems Operation, Testing and Adjusting, "Reverse Currents (EDC) - Calibrate" contained within this manual.