BRACKET AS 5270756 - Caterpillar

Illustration 7 g01012896
Remove bolt (9) and remove pin (10A).
Remove bracket assembly (11). Note: Note washers (12) between the bracket assembly (11) and the rod end of sideshift cylinder (4).Disassembly and Assembly Information
Table 1
Required Tools
Tool Part Number Part Description Qty
A 127-4904 Hydraulic Cylinder Repair Stand 1
B 195-4609 Seal Pick 1
C 9U-7868 Spanner Wrench 1
127-8064 Adapter Plate 1
D 4C-4032 Bearing Mount Compound 1
E 9U-6539 Socket 1
F 1P-0808 Multipurpose Grease 1
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 8 g01012935 (1) Use Tooling (E) in order to torque the bolt. Tighten the bolt to a torque of 900 100 N m (660 75 lb ft). (2) Lubricate sealing lips with a thin covering of the lubricant that is being sealed. (3) Apply Tooling (D) to the wiper seal groove before you assemble the wiper seal to the head. Note: Lubricate the threads with clean grease and torque head (4) to 600 130 N m (440 95 lb ft). Use Tooling (F) to apply the grease.Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 9 g01012792
Attach a suitable lifting device to sideshift cylinder (4). Slide sideshift cylinder (4) on blade (1) and install sideshift cylinder (4). The weight of sideshift cylinder (4) is approximately 91 kg (200 lb).
Illustration 10 g01012896
Install bracket assembly (11).
Install pin (10A) and install bolt (9). Note: Note washers (12) between the bracket assembly (11) and the head end of sideshift cylinder (4).
Illustration 11 g01012764
Position nuts (7) and (8). Install cotter pin (9). Use washers (10) to maintain a maximum clearance of 1.8 mm (0.07 inch) between the bracket assembly and the beam. Tighten nut (8) to zero clearance and back off one slot. Note: Note the location of washers (10).
Illustration 12 g01012763
Install pin (6).
Install cotter pin (5).
Illustration 13 g01012752
Connect hose assemblies (3).
Remove the suitable blocking under sideshift cylinder (4).
Illustration 14 g01012751
Install covers (2).
Illustration 15 g01028525
Position blade (1) to the original location and remove the suitable blocking.