BRACKET AS 5332837 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g00836619
Alignment marks for timing gears
Check the alignment of the timing gears.Note: Ensure that the marks on the timing gears are in alignment. Align the "3" mark on the fuel injection pump drive gear with the "33" mark on the idler gear. Make an alignment of the "2" mark on the idler gear with the "22" mark on the camshaft gear. Align the "1" mark on the crankshaft gear with the "11" mark on the idler gear. The No. 1 cylinder is at the top center position when the timing marks are in alignment.
Illustration 2 g00606022
Ensure that the old gasket material (9) is removed from the mating surface of front housing (4) and the timing gear plate. Install a new gasket (9) .
If the crankshaft front seal (10) (not shown) was removed, use Tooling (A) in order to install a new crankshaft front seal (10) .
Illustration 3 g00606002
Before installation of front housing (4) , check gasket (7) (not shown) for the oil pan for damage. Replace gasket (7) , if necessary. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install" for replacement of gasket (7) for the engine oil pan.
Use two people in order to install front housing (4) onto front plate (8) and the cylinder block. The weight of front housing (4) is approximately 20 kg (45 lb).
Install bolts (6) in order to fasten front housing (4) onto the cylinder block and front plate (8) .
Illustration 4 g00605985
Install the washers and six bolts (5) (not shown) in order to secure front housing (4) onto engine oil pan.
Install bolts (3) and washers that secure front housing (4) to the front plate and the cylinder block.
Illustration 5 g01374908
Connect hose (2) to the front housing.
Tighten hose clamp (1) in order to secure hose (2) to the front housing.End By:
Install the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Install".
Install the crankshaft pulley. Refer to Disassembly and Assembly, "Crankshaft Pulley - Remove and Install".
Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".
Install the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".