BRACKET AS 5565614 - Caterpillar

1. The crankcase oil drain plug is located under the rear of the machine.2. Remove the bolts, washers and engine crankcase access cover from under the upper structure. 3. Open the access cover. 4. Remove the crankcase oil drain plug. Allow the oil to drain into a container.5. Install the drain plug after all of the oil has drained. 6. Place an oil container under the oil filter. Remove the drain plug to allow the oil to drain into the oil container.Two types of oil filters, full-flow and bypass, are used for this engine. Both types of filters can be replaced in the same procedure which follows.
Never reuse a cleaned filter element.
7. Loosen the center bolt and remove the filter case, filter element, and spring. 8. Clean the inside of the filter case with nonflammable solvent.9. Install the drain plug and reassemble the case with a new filter element, gasket and O-ring seal. Torque the center bolt to 6 to 7 kg m (43 to 51 ft lb)Use only Caterpillar genuine filter elements for replacement. 10. Remove the oil fill cap. Fill the crankcase with oil. See "Refill Capacities". Clean and install the cap. 11. Start and operate the engine to fill the filter. Check for leaks. Stop the engine.12. Maintain the level between the ADD and FULL marks on the dipstick. 13. Close the access cover.14. Install engine crankcase access cover.Cooling System
Add Conditioner
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Before removing the radiator fill cap, always pull up on the decompression lever provided on the cap to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Do not add conditioner monthly unless the engine has actually operated 250 service hours. Adding conditioner before 250 service hours will result in an excessive concentration of conditioner.Do not use Caterpillar coolant conditioner elements with Dowtherm 209 Full-Fill coolant. Follow recommendations provided with Dowtherm 209 Full-Fill coolant.
1. Unlock and open the cover. 2. Pull up on the decompression lever on the radiator cap to relieve pressure and then remove the radiator cap.3. Add 0.24 liter (0.06 gal) of Caterpillar cooling system conditioner, to provide a 3% to 6% concentration in the coolant.4. Replace the cap if the gasket is damaged. Install the radiator cap.5. Close and lock the cover.Final Drive
Check the