BRACKET ASSEM. 5F4347 - Caterpillar

Lift The Cab/ROPS/Platform
1. Remove the bolt and washer that fasten the bar assembly for the bucket positioner and kickout to the pin which connects the bucket lever to the tilt cylinder. See Illustration 9.2. Use the bolt and washer to fasten the 6V2157 Link Bracket to the right side of the pin as shown in Illustration 9.
Illustration 9. Installation of 6V2157 Link Bracket on pin that connects bucket lever and tilt cylinder.3. Install the hooks on the two-leg chain through the top, rear lift eyes on the cab/ROPS. Pull the ring on the chain to the front of the cab/ROPS.4. Connect the 5P9694 Ratchet hoist to the 6V2157 Link Bracket and to the two-leg chain as shown in Illustration 10.
Illustration 10. Correct installation of 5P9694 Ratchet Hoist and two-leg chain for Procedure B.5. Remove the top bolt from the top hinge for the righthand access door. Install a 5P9736 Link Bracket with the original bolt. See Illustration 11.6. Fasten the other 5P9736 Link Bracket, the 1A8063 Bolt and the 1B4331 Washer to the bracket for the rod end of the tilt cylinder. See Illustration 11.7. Connect the 8S9906 Ratchet Hoist between the two link brackets. See Illustration 11.
Illustration 11. Correct installation of 5P9736 Link Brackets and 8S9906 Ratchet Hoist for Procedure B.8. Tighten the ratchet hoist on the front of the machine until it holds the weight of the cab/ROPS/platform, and remove the top two bolts from the support bracket.9. Slowly work both hoists to tilt the cab to 90°.10. Install the bolt, nut and washer through the brace group at the front of the machine. See Illustration 8. The cab/ROPS/platform is now tilted to 90°.Lower the Cab/ROPS/Platform
1. Tighten the 5P9694 Ratchet Hoist, at the front of the machine, so that it holds the weight of the cab/ROPS/platform.2. Remove the bolt, nut and washer from the brace group at the front of the machine. See Illustration 8.3. Slowly lower the cab/ROPS/platform with the 5P9694 Ratchet Hoist. Make sure the rod for the governor linkage slides straight into the upper sleeve.4. Lower the cab/ROPS/platform until the upper bolts can be installed in the support bracket.5. Remove the ratchet hoists and the link brackets. Reinstall the bar assembly for bucket positioner and kickout. Reinstall the top bolt in the top hinge for the access door. See Illustration 9. The cab/ROPS/platform is now at 24°.Procedure C - Method To Tilt Platform Without A Cab Or A ROPS
Lift The Platform
1. Install a 6V2157 Link Bracket and a 1D4606 Bolt on the inner, rear bolt hole at the right of the operator's seat as shown in Illustration 12.2. Install a 5P9736 Link Bracket and a 6H1717 Bolt in each of the two tapped blocks that are behind the operator's seat. The block to the left of the seat is shown in Illustration 12.3. Remove the bolt and washer that fasten the bar assembly for the bucket positioner and kickout to the pin which connects the bucket lever to the tilt cylinder. See