BRACKET A.-LH 5K5108 - Caterpillar

Illustration 1 g00104545Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Personal injury or death can result from sudden work tool movement.Sudden movement of the work tool can cause injury to persons near the work tool.To prevent injury or death, make sure that the area around the work tool is clear of personnel and obstructions before operating the work tool.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Required Parts
Table 1
563-6820 Auxiliary Control Ar (- 03)
Qty Part No. Description Media
(1) 516-7681 Front Lines Gp M0095319
(1) 516-7683 Pilot Lines Gp M0095321
(1) 516-7682 Hydraulic Pump Lines Gp M0095323
(1) 512-0950 Gear Pump and Mounting Gp M0095327
(1) 516-8480 Chassis Wiring Gp M0089549
(1) 533-1276 Film - Installation of the Films
Illustration 2 g06317509
533-1781 Film Gp
(1) 250-8054 Hammer Film
(2) 260-6941 Controls Film
Illustration 3 g06317508
(3) 533-1276 FilmTuning Section
Reference: M0086312, "330, 336, 336 GC and 340 Excavator Tool Control"Systems Operation Testing and Adjusting, Process for setting Up the Work Tool.