BRACKET 5K5163 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
3 5P5623 WIRE-ELECTRICAL
3 9X3401 PIN-CONNECTOR
1 9X3402 SOCKET-CONNECTOR
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 15% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
1. Remove the 334-5941 power module.
2. Rewire the connection to the Fuel Control Valve to allow the Engine Electronic Control Module (ECM) to provide power to the FCV.
Refer to attached Rework Procedure for details.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-20000 hrs,
0-60 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 3.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
1. Refer to the C175 Disassembly and Assembly Guide RENR7466 for instructions on how to access the engine ECM Panel.
2. Disconnect the wire harness connection to the power module (4).
3. Remove the power module (4).
4. Reinstall the bolts, washers, and nuts to prevent potential water entry through the mounting holes.
Image1.1.1
5. Disconnect and remove wires 35 and 36 at the power connector (3).
6. Disconnect and remove wires 16 and 17 at the RH rail connector (2).
Image1.2.1
7. Connect a 16ga black wire between pin 6 of the ECM J2 connector (1) and pin 16 of the RH rail connector (2).
8. Connect a 16ga black wire between power connector pin 36 and RH rail connector pin 17.
Terminate the new wires with the appropriate 9X-3401 or 9X-3402 Connectors.
Refer to Image1.3.1 and Image1.3.2.
Image1.3.1
Image1.3.2
9. Check that the wires are properly secured and engine operates as intended.