BRACKET 5N2752 - Caterpillar

Illustration 37 g02415437
Left Mounting Plate
Illustration 38 g02432158
Alternate View of Left Mounting Plate
Position plate (1) onto blade. Plate should be flush with the front of the bracket assembly. Attach plate (1) onto bracket assembly with welds (W1) along the top and bottom of the plate (1) where material allows.
Illustration 39 g06173700
Right Mounting Plate
(2) 245-4245 Plate
(B) 10 2 mm (0.4 0.08 inch)
Refer to Illustration 38 for measurements and locations of plate (2).
Illustration 40 g02419836
Right Mounting Plate
Position plate (2) onto blade. Plate should be flush with the front of the bracket assembly. Attach plate (2) onto bracket assembly with welds (W1) along the top of the plate (2) where material allows.Center 450-5796 Bracket As (3) Instructions for ARO for Dual Tilt
The blade comes from factory with the left-hand bar welded in place to assist in locating and fixing the mounting bracket to the blade. To install the mounting bracket, perform the following steps:
Illustration 41 g06173712
(3) 450-5796 Bracket As
(4) 434-3129 Plate
Place the bracket (3) to the right of the center mast bar , with the lower portion of the leg located 16mm above the bottom of the bar.
Verify that the top plate of bracket (3) surface is parallel to the cutting edge/bolts and use an 8mm fillet weld on the right-hand (exposed) edge to mount.Note: Neither bar has a weld on the inside leg. If the machine is equipped with sweeps, do not use the center bracket. Instead, use the left side plate for mast mounting.Install Handle Assembly (MB8 and JR8 ONLY)
Table 13
386-4201 Handhold Gp
Item Qty Part Number Description
1 1 346-6945 Handhold As (LH)
2 1 346-6946 Handhold As (RH)
3 2 348-8717 Plate
4 6 329-3356 Nut
5 6 8T-4132 Nut
6 6 8T-4175 Bolt
7 6 8T-4194 Bolt
8 12 8T-4223 Hard Washer
9 12 9X-8257 Washer
Illustration 42 g03694260
Illustration 43 g03694263
LH side handhold assembly
Install handhold assembly (1) to plate assembly (3) with three bolts (7), six washers (8), and three nuts (4).
Install handhold assembly (1) and plate assembly (3) to the push arm with three bolts (6), six washers (9) and three nuts (5).
Illustration 44 g03694266
RH side handhold assembly
Install handhold assembly (2) to plate assembly (3) with three bolts (7), six washers (8), and three nuts (4).
Install handhold assembly (2) and plate assembly (3) to the push arm with three bolts (6), six washers (9) and three nuts (5).