BRACKET 5T4030 - Caterpillar

Introduction
The following procedure is for adjusting the ride control activation speed with Caterpillar Electronic Technician (Cat ET).The software program that will be used for this test procedure is the Cat ET. The Cat ET is a software program that can be used on an IBM-compatible personal computer.Reference: For more information about the use of Cat ET, refer to Troubleshooting, "Using Caterpillar Electronic Technician to Determine Diagnostic Codes" for the machine that is being serviced.Required Tools
Illustration 1 g03142124
Table 2
Required Tools
Tool Item Qty Part
Number Description
C 1 317-7484(1) Communication Adapter Gp
C1 1 370-4617 Cable As (USB PC Communication)
C2 1 317-7485 Communication Adapter III
C3 1 327-8981 Cable As (Data Link)
C4 1 317-7492 Cable As Wireless Radio
C5 1 JERD2129 Caterpillar Electronic Technician (Cat ET)
(1) Cat Electronic Technician (ET) and Software CD, NETG5057 are required when using the communication adapter.Test Preparation
Park the machine on a smooth, level surface.
Shift the transmission direction control switch to the NEUTRAL position.
Lower the bucket or the work tool to the ground.
Engage the parking brake.
Place blocks in front of the wheels and behind the wheels.
Allow only authorized personnel on the machine. Keep unauthorized personnel off the machine and in clear sight of the operator.
Shut off the engine. Note: This calibration procedure can be performed without a running engine.
Turn the key start switch and the disconnect switch to the ON position. Adjustment Procedures
Procedure for Adjusting the Ride Control Activation Speed with the Graphic Display
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.Prevent possible injury by performing the procedure that follows before working on the machine.
Illustration 2 g03582899
On the primary display screen, select the "Machine Information/Settings" button (A).
Illustration 3 g03582900
Select the "Settings" button (B).
Select the "Ride Control" button (C).
Select either the "Rd Ctrl Fwd Act Spd " or the "Rd Ctrl Rev Act Spd " setting and adjust to the desired speed.
Exit to the "Main Screen". Procedure for Adjusting the Ride Control Activation Speed in Caterpillar Electronic Technician (Cat ET)
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.Prevent possible injury by performing the procedure that follows before working on the machine.
Connect the laptop computer to the service connector in the cab. The service connector is located on the right side instrument panel above the key start switch. Note: The Cat ET will allow the activation speed for the ride control to be adjusted in 0.1 km/h (0.06 mph) increments. The engagement speed may be adjusted between 1.6 km/h (1 mph) to 32 km/h (20 mph). The factory setting for the activation speed (forward) is 9.7 km/h (6 mph). The factory setting for the activation speed (reverse) is 3.2 km/h (2 mph).Note: The deactivation speed will be 1 km/h (0.62 mph) less than the activation speed.
Open the software program Cat ET. Select the "Implement ECM" from the "ECM Selector" menu.
Select the "Service" menu item from the toolbar. Select