BRACKET AS 6G4224 - Caterpillar

start by:a) remove timing gear cover 1. Remove suction tube (1).2. Remove bolt (2), lock and clip. 3. Remove sleeve (6), guide (5), spring (8) and plunger (3). If the valve assembly will not come out after the clip is removed, hit guide (5) with a soft hammer to loosen it.4. Remove three bolts (4) and locks.5. Remove oil pump cover (7). 6. Remove inner rotor (9) and outer rotor (10).7. Remove bearing (11) from the cover. 8. Remove the bearing from the inner rotor with tooling (A).Install Oil Pump And Relief Valve
The rotors must have a replacement made as a set. 1. Install the bearing in inner rotor (6) with tooling (A). 2. Install shaft (2) in timing gear cover to dimension (Y) .860 in. (21.8 mm) from the end of the shaft to the bottom face of the counterbore in the cover.3. Install bearing (1) in the timing gear cover to dimension (X) .344 in. (8.7 mm). Use tool (B) to install bearing (1). 4. Install inner rotor (6) and outer rotor (5) as a set only.5. Check the clearance for the oil pump rotor tip (4) with feeler gauge (3). Rotor tip clearance is .004 .002 in. (0.10 0.05 mm). Maximum permissible rotor tip clearance is .009 (0.21 mm). 6. Install cover (7), locks and bolts (8).7. Bend the locks on bolts (8).8. Check the oil pump end clearance with feeler gauge (3). End clearance is .004 .002 in. (0.10 0.05 mm). 9. Install plunger (14), spring (10), guide (9) and sleeve (11). Be sure sleeve (11) is installed with groove (slot) (13) down as shown. After the clip (not shown) is installed in groove slot (13), the top of sleeve (11) must be .003 in. (0.58 mm) above the machined surface of housing.10. Install clip (not shown) in groove (slot) (13) and install bolt and lock to hold clip.11. Bend lock on bolt and install suction tube.end by:a) install timing gear cover