BRACKET 6K0039 - Caterpillar

Illustration 2 g00953870
There are several specific safety messages on your machine. The exact location of the safety messages and the description of the hazard are reviewed in this section. Please take the time in order to become familiar with the safety messages.If a safety message is damaged or missing, the safety message must be replaced. If a safety message cannot be read, the safety message must be replaced. If a safety message is located on a part that has been replaced, a new safety message must be placed on the new part. Consult your Caterpillar dealer for new safety messages.Do Not Operate
This safety sign (1) is located on the operator console.
Illustration 3 g00665990
Do not operate this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual.Failure to follow the instructions or heed the warnings could result in injury or death.Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Improper Connections for Jump Start Cables
The safety signs (2) are located near the battery compartments.
Illustration 4 g00038786
Improper jump start cable connections can cause an explosion resulting in personal injury.Batteries may be located in separate compartments. When using jump start cables, always connect the positive (+) to the positive (+) terminal of the battery that is connected to the starter solenoid and the negative (-) cable from the source to the negative (-) terminal of the starter. (If the machine is not equipped with a starter negative terminal, connect the negative (-) cable to the engine block.) Follow the procedure in the Operation and Maintenance Manual.
No Clearance and Steering Frame Lock Pins
This safety sign (3) is located in the steer pivot on both sides of the yoke.
Illustration 5 g00666024
Illustration 6 g00666029
No clearance for a man in this area when the machine turns. Severe injury or death from crushing could occur.Install the steering frame lock pin into the locked position before lifting the machine, transporting the machine on another vehicle, or performing service near the center of the machine.Disengage the steering lock pin from articulation joint and store in retainer before resuming operation or the machine will not steer.
ROPS Structure
This safety sign (4) is located on the ROPS.
Illustration 7 g00984486
The protection offered by this ROPS will be impaired if the ROPS has been subjected to any modification, structural damage, or has been involved in an overturn accident. This ROPS must be replaced after a roll-over. Seat belts must be worn while operating the vehicle.