BRACKET ASSEM. 6K6940 - Caterpillar

Remove Governor Drive Housing (Upper) (Woodward Ug-8)
start by:a) remove governor 1. Disconnect tube assembly (3) from housing assembly fitting.2. Remove six bolts (1) and housing assembly (2).Install Governor Drive Housing (Upper) (Woodward Ug-8)
1. Inspect the governor drive housing gasket and make a replacement if damaged. Install gasket. 2. Put housing assembly (1) in position and install six bolts.3. Connect tube assembly (2) to housing assembly fitting.end by:a) install governorDisassemble Governor Drive Housing (Upper) (Woodward UG-8)
start by:a) remove governor drive housing 1. Remove gear assembly (2) from housing. Gear assembly (3) must be disassembled in housing for removal. Gear assembly (2) is removed as a unit. 2. Remove ring (1) from shaft with tooling (D).3. Remove gear (4) and washer (5) from shaft. Remove shaft (6) from housing. 4. Remove ring (7) with tool (A). Remove gear (8) and washer (9) from shaft (10). 5. Remove bearing (11) and two bushings (12) from housing with tool (B).Assemble Governor Drive Housing (Upper) (Woodward UG-8)
1. Install bearing (1) in housing with tool (A). The hole in the bearing must be in alignment with the housing opening for oil supply.2. The bushings installed with tool (A) must be even (flush) with the edge of the housing bore. 3. Put shaft (2) in housing and install washer, gear (4) and ring (3) with tool (B). 4. Install washer (7) and gear (6) on shaft (8). Install ring (5) with tool (B).5. Put gear assembly in housing.end by:a) install governor drive housing