BRACKET 6N5370 - Caterpillar

Roading
Inflate tires to correct pressure. Consult your tire dealer for recommended tire pressure for roading.Bring water, oil and fuel up to proper level.Do not travel over 25 mph (40 kmph).Every 25 miles (40 km) or 1 hours, stop for 30 minutes to inspect the machine and let tires and parts cool.Obey all traffic regulations.Shipping
Investigate travel route for overpass clearances. Make sure there will be adequate overhead clearance.
Block trailer or rail car wheels before loading.Stop engine, turn disconnect switch OFF and remove key.Block wheels and secure truck with tie-downs.Wire the accelerator in shut off position.Use extreme care to avoid slipping if loading dock or ramp has ice, snow, grease or oil on it.Check with authorities for weight limits and overhead clearance of proposed route.Block and tie truck securely.Observe all safety regulations.Remove ice, snow or other slippery material from loading bed, before loading, to prevent truck slipping in transit.Cover exhaust opening.Check regulations covering transportation of cylinders containing compressed gas (Suspension cylinders.)Towing
These instructions are for emergencies ONLY. Always haul the machine if long distances must be traveled.Do not tow over 5 mph (8 kmph).Tow the truck forward if possible.The engine must be running to provide steering and braking.If truck cannot be towed forward, disconnect steering drag link.If an internal transmission or drive line failure is suspected, remove rear axle shafts.