BRACKET AS-RH 6Y0174 - Caterpillar

Image1.3.1
6. Add a second 132-5789 Ladder Clip on the antenna bracket bolt.
7. Remove the extra wire length and attach properly the antenna wire with two 3S-2093 Strap Cable.
Refer to Image 1.4.1.
Image1.4.1
8. Check the 365-6510 Cable As routing following steps below. Replace the 365-6510 Cable As. by the same part number if it is damaged.
9. Attach properly the 365-6510 Cable As. with one 3S-2093 Straps.
Refer to Image 1.5.1.
Image1.5.1
10. Attach properly the 365-6510 Cable As. with four 3S-2093 Straps.
Refer to Image 1.6.1.
Image1.6.1
11. If there is the harness ARO, in the first one attach the harness ARO on one branch of the link with a 3S-2093 Strap. Attach after the 365-6510 cable As. with a 3S-2093 Strap. Don?t crush the Cable As. with the harness.
Refer to Image 1.7.1.
Image1.7.1
12. Use 7K-1181 Strap cable to maintain the extra harness ARO on the link. Attach the 365-6510 Cable As. on the Harness ARO with a 3S-2093 Strap Cable. Don?t crush the Cable As. with the harness.
Refer to Image 1.8.1.
Image1.8.1
13. If there is the harness ARO, In the first one attach the harness ARO on one branch of the link. Attach after the 365-6510 Cable As. Don?t crush the Cable As. with the harness.
Refer to Image 1.9.1.
Image1.9.1
14. If there is the harness ARO, attach together harness and the 365-6510 Cable As. with a 3S-2093 Strap.
Refer to Image 1.10.1.
Image1.10.1
15. Inside the enclosure , attach the 365-6510 Cable As. on the ladder clip with a 3S-2093 Strap.
Refer to Image 1.11.1.
Image1.11.1
16. Attach the Cable As. with 3S-2093 Strap (3) on current harness.
17. If the 365-6510 Cable As. is replaced or disconnected from the Product Link module, apply Loctite 222 on connector threads before the connection.
Refer to Image 1.12.1 and 1.12.2.
Image1.12.1
Image1.12.2
18. Test the Product Link Antenna communication with satellites via ET.
Refer to Image 1.13.1.
Image1.13.1