BRACKET 7B0558 - Caterpillar

Assemble the 263-7163 Insert Installation Tool (M36 Thread). See Illustration 9 through Illustration 11.
Illustration 10 g02459164
Apply an anti-seize compound to the stud and the drill washer in order to prevent the stud and the drill washer from locking to the insert.
Screw the 263-7164 Threaded Insert (M36 Thread) onto the stud.
Place the drill washer over the stud.
Screw the nut onto the stud.
Illustration 11 g02459180
Adjust the depth so the bottom of the stud is flush with the bottom of the insert. See Illustration 11.
Illustration 12 g02459192
Apply Sealant to the hole.
Illustration 13 g02459216
Screw the 263-7164 Threaded Insert (M36 Thread) into the tapped hole.
Illustration 14 g02459236
Torque the insert until the washer on the installation tool is flush with the surface.
Use a wrench to prevent the stud from turning and remove the nut.
Remove the drill washer.
Illustration 15 g02459258
Illustration 16 g02459276
Adjust the length of the drill bit in order to match the length of the locking pins that are supplied.Note: Locking pins are included with the 263-7144 Full Torque Thread Insert Kit (M36 Thread) and with the 263-7164 Threaded Insert (M36 Thread). Locking pins are not sold separately. Locking pins do not have a separate part number.
Place the tube of the drill or drill stop over a number 29 drill bit.
Place the end of the drill bit into a drill with at least 2000 rpm.
Place the drill washer and the locking pin over the end of the drill bit and adjust the drill so the length of the exposed drill bit is equal to the length of the drill washer and locking pin.
Illustration 17 g02459277
Place the drill washer onto the stud again.
Rotate the washer so that the hole is at the desired location.
Drill the locking pin hole to depth.
Illustration 18 g02459281
Rotate the washer by 180°.
Drill a second locking pin hole to depth.
Illustration 19 g02459283
Remove the washer and the stud from the insert.
Apply one drop of 263-7259 Sealant in each hole.
Illustration 20 g02459286
Insert the locking pins into the drilled holes.
Illustration 21 g02459290
Drive the locking pins so the locking pins are flush with the surface of the part.
Wipe any excess sealant off the surface.
Repeat Step 2 through Step 27 on the other damaged holes.