BRACKET 7B5822 - Caterpillar

Illustration 71 g01397483
Use the following hardware in order to install Plate Assemblies (20) to the hydraulic tank:
Four Locknuts (A)
Four Bolts (B)
Four Bolts (19)
Remove the existing Locknuts (A) .
Save the existing Locknuts (A) .
Remove the existing Bolts (B) .
Discard the existing Bolts (B) .
Illustration 72 g01397512
Use new Bolts (19) in place of discarded Bolts (B) in order to attach Plate Assemblies (20) to the hydraulic tank.
Reuse Locknuts (A) with new Bolts (19) .
Illustration 73 g01397521
Illustration 74 g01398335
View of Area AYLocation of block on cover assembly
Illustration 75 g01397536
Use the following hardware in order to install Cover As (23) to the hydraulic tank:
Nine Bolts (11)
One Hard Washers (12)
Eight Washers (21)
One Clip (22)
Illustration 76 g01398620
Illustration 77 g01398704
Illustration 78 g01398993
Use the following hardware in order to install Baffle (24) and Baffle (25) to Cover As (23) :
Seven Bolts (11)
Seven Hard Washers (12)
Illustration 79 g01398786
Illustration 80 g01399043
Use the following hardware in order to install Covers (26) to Cover As (23) :
Four Bolts (27)
Illustration 81 g01399157
Location of connector cap
Locate the connector for the automatic lubrication pump. The connector is part of Chassis Harness As (28) .Note: The connector for the automatic lubrication pump should already be clipped to the front side of the mounting arm for the hydraulic tank. The connector for the automatic lubrication pump should be covered by a cap. The connector for the automatic lubrication pump should be labelled with a paper tag. The paper tag should read "AUTOLUBE SOL".
Illustration 82 g01399319
Location of the uncapped connector of the automatic lubrication pump
Remove the cap from the connector for the automatic lubrication pump.
Illustration 83 g01399502
Location of the power lead from the automatic lubrication pump
Connect the power lead from the automatic lubrication pump to the "AUTOLUBE SOL" connector on the Chassis Harness As (28) .Note: A technician will probably be required to change the status of "Not Installed" to "Installed" by using Caterpillar Electronic Technician (ET) under the configuration files of the chassis ECM.Note: Refer to Systems Operation Testing and Adjusting Manual, RENR8265, "Automatic Lubrication System - Test" in order to do the following:
Pressurize the system.
Make sure that the pump is working properly.
Check for leaks.