BRACKET 7E6308 - Caterpillar

Illustration 91 g02401176
Testing the object detection coverage area at the front of the machine
The person in the cab of the machine will inform the person moving the object when to mark the coverage start/stop point. The start/stop points must be marked when the object first appears or first disappears from radar coverage on the display. The designated reference point for the rear radar will be the center of the machine. The distance from the initial perpendicular detection must be measured and should be approximately 2 m (6.6 ft) from the front of the machine. Refer to Illustration 92.
Illustration 92 g02401217
Sample of object detection coverage area at the front of the machine
If the detection area is not approximately 10 m (32 ft) long by 7 m (23 ft) wide, or the coverage area contains holes, adjust the angles of the brackets for the object detection sensors. Refer to the "Adjust the Object Detection Sensors" section of this manual for additional information regarding the adjustment of the brackets.Note: If the detection area is larger than the dimensions listed above, adjustment of the object detection sensors is not required.Operate the machine to