BRACKET AS 7I4963 - Caterpillar

Illustration 1 g03885422
Right Implement Pedal Position Sensor Schematic
This diagnostic code is associated with the Right Implement Pedal Position Sensor. The FMI 04 means that the ECM has determined that the voltage of the circuit for the position sensor is below normal. The Right Implement Pedal position control has an output frequency of approximately 500 Hz. The duty cycle of the signal changes as the Right Implement Pedal position is changed. The duty cycle increases as the Right Implement Pedal is depressed. The Right Implement Pedal values are dependent on the Right Implement Pedal linkage. Valid values range from 5% to 95% duty cycle.The possible causes of this diagnostic code are listed below:
Improperly adjusted Right Implement Pedal linkage.
The signal circuit for the sensor is shorted to ground.
The sensor has failed.
The ECM has failed. The ECM is unlikely to fail.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 5001 FMI 04 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The diagnostic code will generate a level 2 warning. Electronic Anti-Stall will be disabled and the Hystat transmission will be limited to low speed.Test Step 1. Check The Output Of The Sensor
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the signal wire (contact C).
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along the ground wire (contact B).
Turn the key start switch to the ON position.
Measure the duty cycle of the signal. The valid sensor range is 5% duty cycle to 95% duty cycle. This fault occurs for <5% duty cycle. Expected Result:The duty cycle is less than 5% for the whole range of the Right Implement Pedal.Results:
OK - The duty cycle is less than 5% for the whole range of the Right Implement Pedal . Proceed to Test Step 2.
NOT OK - The signal from the sensor is only invalid for part of the Right Implement Pedal range.Repair: The sensor is not adjusted correctly. Adjust the Right Implement Pedal linkage so the sensor signal is valid through the entire range.STOPTest Step 2. Check The Sensor
The key start switch remains in the ON position.
Ensure that the diagnostic code is active.
Observe the status of the diagnostic code. Disconnect the sensor from