BRACKET 7S5846 - Caterpillar

Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    Start By:
Remove the cab. Refer to Disassembly and Assembly, "Cab - Remove".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.Note: The hydraulic tank is located directly behind the cab.
Open the engine hood.
Drain the oil from the hydraulic tank. The tank capacity is 55 L (14.3 US gal).
Illustration 1 g00282521
Loosen clamp (2). Remove precleaner assembly (1) from the air cleaner.
Illustration 2 g00282522
Remove four bolts (3) and the washers.
Illustration 3 g00282524
Loosen clamp (5). Remove exhaust pipe (4) .
Illustration 4 g00282525
Remove hydraulic oil filler cap (7). Remove ten bolts (6) and the washers.
Illustration 5 g00282566
Install suitable lifting slings on cover (8). Use a hoist to remove the cover from the hydraulic tank. The weight of cover (8) is 36 kg (80 lb).Note: Install hydraulic oil filler cap (7) after cover (8) has been removed.
Illustration 6 g00282567
Disconnect hose assemblies (9) and (10) .
Illustration 7 g00282568
Disconnect hose assemblies (11) and (14) .
Disconnect tube assemblies (12) .
Disconnect electrical connector (13) .
Illustration 8 g00282569
Install Tooling (A) on the hydraulic tank. Fasten a suitable lifting chain and a hoist to Tooling (A), as shown.
Illustration 9 g00282570
Illustration 10 g00282571
Remove bolts (15), washers (16), washers (18), mounts (17) and tubes (19) .
Use a hoist to remove the hydraulic tank. The weight of the hydraulic tank is 100 kg (220 lb).