BRACKET AS-RH 8E8605 - Caterpillar

Illustration 1 g02549717
The "Settings" menu allows the user to view the parameters for the following:
Display Setup
Operator Config
Machine ConfigOperating conditions, preferences of the operator and requirements for operating efficiency dictate the need to adjust the parameters. Parameters that are displayed are based on the setup of the machine. Advisor reads what options are enabled and give the options to change the corresponding settings.Note: Cat ET can be used in order to change settings.The "Settings" menu option is entered by selecting "Settings" from the "Home Menu". Press the up arrow button or the down arrow button until "Settings" is highlighted in order to select the "Settings" menu. Then press the "OK" button. Refer to Illustration 2.Note: The "Home Menu" can be displayed from any screen by pressing the "Home" button.
Illustration 2 g02624076
The following screen will now be displayed.
Illustration 3 g01451916
The "Settings" menu organizes the parameters into three categories. These categories have adjustable parameters. The three categories are "Display Setup", "Operator Config", and "Machine Config".To adjust the associated parameters, press the up arrow button or the down arrow button until the desired category is highlighted. Then press the "OK" button in order to access the parameters in that category. From this point, follow the instructions on the screen in order to adjust the available parameters.Display Settings
From the "Display Setup" menu, use the appropriate up arrow button or the down arrow button in order to highlight the desired parameter. Then press the "OK" button to allow access to that screen. Then follow the instructions on the screen in order to adjust the parameter. All of the parameters in this category relate to the preferences of the operator in regard to the Advisor display. The following parameters may be adjusted:
Contrast
Lights ON
Lights OFF
Language
Units
Date Format
Time Format
Dash Cluster OptionOperator Config
From the "Operator Config" menu, use the appropriate up arrow button or the down arrow button in order to highlight the desired parameter. Then press the "OK" button to allow access to that screen. All of the information in this category relates to the electronic control module. The following information may be viewed:
Reduced Rimpull
Ride Control Speeds
Detent SettingsMachine Config
From the "Machine Config" menu, use the appropriate up arrow button or the down arrow button in order to highlight the desired parameter. Then press the "OK" button to allow access to that screen. The Advisor must be in Service Mode in order to change the settings of the transmission gears. See the Systems Operation, "Service Mode" section of this manual for more information. All of the information in this category relates to the electronic control module. The following information may be viewed:
Lube Cycle Time
Control Throttle
Transmission Gears
Pop-up Message Config