BRACKET 8P3127 - Caterpillar

Removal Procedure
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01292468
Disconnect harness assembly (2). Remove inlet manifold temperature sensor (1) .Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 2 g01292468
Install inlet manifold temperature sensor (1). Tighten inlet manifold temperature sensor (1) to a torque of 20 3 N m (15 2 lb ft). Connect harness assembly (2) .