BRACKET AS 9D1916 - Caterpillar

Illustration 9 g00628035
Note: Do not damage exposed stator windings or field windings. Bumping the windings or scraping the windings may break the insulation. Broken insulation may create a short circuit or a ground.
Join housing (31) and housing (14). Install 4 bolts (30) .
Illustration 10 g00627853
Note: Many of the alternator's internal components are covered with dielectric grease. If the grease is removed, reapply the grease.
Illustration 11 g00627855
Install Insulator (29). Install the heat sink and diode assembly (12) in housing (14) .
Illustration 12 g00627840
Install separator (28) .
Install alternator output terminal (27). Install insulator (26). Install the nut and washer (25) .
Install diode trio (24) and install screw (23) .
Illustration 13 g00627832
Install the 3 screws and insulators (18). Connect wire (19) .
If the "R" terminal is used, install the following components: nut (20), lead (21), the washer and terminal (21) .
Illustration 14 g00627820
Install the screw and insulator (16). Connect capacitor lead (17) .
Illustration 15 g00627810
Note: The 3 output diodes (11) are located in heat sink (12). These diodes are identical in polarity. Diode (11) has red insulation on the wire. The 3 ground diodes (13) are located in housing (14). These diodes are identical in polarity. Diode (13) has black insulation on the wire.
Connect 6 diode leads. Connect 3 phase leads. Connect 3 stator phase leads. Install 3 nuts (15).
Table 1
Alternator Ground    Current Flow of the Output Diodes    Current Flow of the Ground Diodes    
Negative     Lead to the Heat Sink     Housing to the Lead    
Red Wire Black Wire    
Illustration 16 g00627808
Install mounting plate (10).
Illustration 17 g00627804
Install regulator (9) .
Install grounded mounting screw (8) .
Illustration 18 g00627796
Install 2 insulated screws (6). Connect the 3 leads.Note: The regulator and the mounting plate are coated with dielectric grease. If the grease is removed, reapply the grease.
Install nut (7) and connect the wire.
Illustration 19 g00627794
Install gasket (5) .
Illustration 20 g00627792
Position cover (4). Install 7 screws (3) .
Illustration 21 g00627790
Position plate (2). Install 4 screws (1) .
Install the fan, the pulley, the washer, and the pulley nut.