BRACKET 9DE9982 - Caterpillar

Illustration 1 g01223332
Illustration 2 g01223333
Position the work tool with the shells in the open position on a flat surface. Refer to Illustration 1 for the correct position. You may also position the work tool on the side with the shells in the open position on a flat surface. Refer to Illustration 2 for the correct position.
Stop the engine of the host machine in order to prevent inadvertent movement of the work tool.
Illustration 3 g01247624
Note: In order to gain access to rotator head bolts (6, 7) on the inside of housing (4) , remove cover (1) from both sides of housing (4) .
Remove bolts (2) and washers (3) .
Remove cover (1) from both sides of housing (4) .
Illustration 4 g01247282
Check the static inspection torque of all rotator head bolts (6) in outer ring (5) of the rotator. Use appropriate tooling in order to apply the torque that is specified in Table 1. Check all of the rotator head bolts (6) in outer ring (5) of the rotator.
Table 1
Static inspection torque    
Sales model     Bolt size     Torque value    
VRG-20/2     M16 x 2     230 N m (170 lb ft)    
VRG-25/2    Note: The rotator head bolt (6) should not move before a torque that is specified in Table 1 is reached. If rotator head bolt (6) moves, then the sealant has been broken and the rotator head bolt has been overstressed. All rotator head bolts (6) and the washers in outer ring (5) must then be replaced.ReferenceContact your Verachtert dealer for replacement of the rotator head bolts.
Illustration 5 g01247649
Illustration 6 g01247650
Check the static inspection torque of all rotator head bolts (7) in the inner ring of the rotator. Use appropriate tooling in order to apply the torque that is specified in Table 1. Only four rotator head bolts (7) will be accessible at a time through the inspection holes (8) . Check all of the rotator head bolts (7) in the inner ring of the rotator.Note: Rotate the work tool in order to access all rotator head bolts (7) .Note: The rotator head bolt (7) should not move before a torque that is specified in Table 1 is reached. If rotator head bolt (7) moves, then the sealant has been broken and the rotator head bolt has been overstressed. All rotator head bolts (7) and the washers in the inner ring must then be replaced.ReferenceContact your Verachtert dealer for replacement of the rotator head bolts.
Install cover (1) . Install washers (3) and bolts (2) . Install the cover assemblies on both sides of housing (4) .