BRACKET AS 9R9334 - Caterpillar

Inspection
Belt tension should be checked initially between the first 20 to 40 hours of engine operation.Check the belt tension. Refer to the Operation and Maintenance Manual, "Maintenance Interval Schedule" topic (Maintenance Section) for the proper intervals.To check the belt tension, apply 110 N (25 lb ft) of force midway between the pulleys. A correctly adjusted belt will deflect 9 mm (0.35 inch) to 15 mm (0.59 inch).To maximize the engine performance, inspect the belts for wear and for cracking. Replace belts that are worn or damaged.For applications that require multiple drive belts, replace the belts in matched sets. Replacing only one belt of a matched set will cause the new belt to carry more load because the older belt is stretched. The additional load on the new belt could cause the new belt to break.If the belts are too loose, vibration causes unnecessary wear on the belts and pulleys. Loose belts may slip enough to cause overheating.If the belts are too tight, unnecessary stresses are placed on the pulley bearings and on the belts. These stresses may shorten the service life of the components.Remove the belt guard. Inspect the condition and adjustment of the alternator belts and accessory drive belts (if equipped).If the belt does not require replacement or adjustment, install the belt guard. If the belt requires adjustment or replacement, perform the following procedure to adjust the belt tension.
If the engine is equipped with a refrigerant compressor (air conditioner), the belts for the following components will have automatic belt tensioners: the alternator, the fan drive and the accessories
If the engine is not equipped with a refrigerant compressor, the alternator is used to adjust the belt tension.Adjustment
Alternator Belt
Illustration 1 g01075759
(1) Adjusting bolt
(2) Mounting bolts
Slightly loosen mounting bolts (2) and adjusting bolt (1).
Move the pulley in order to adjust the belt tension.
Tighten adjusting bolt (1) and mounting bolts (2). For the proper torque, refer to the Specifications Manual, SENR3130, "Torque Specifications".
Install the belt guard. If new belts are installed, check the belt tension again after 30 minutes of engine operation at the rated rpm.Water Pump Belt
Illustration 2 g01075753
Exploded view of the drive assembly for a water pump belt
(1) Mounting bolt
(2) Square hole
(3) Adjusting bolt
Slightly loosen mounting bolts (1) and adjusting bolt (3).
Adjust the belt tension with a square drive in square hole (2).
Tighten adjusting bolt (3) and mounting bolt (1). For the proper torque, refer to the Specifications Manual, SENR3130, "Torque Specifications".
Install the belt guard. If new belts are installed, check the belt tension after 30 minutes of engine operation at the rated rpm.