BRAKE GP-SWING 1106198 - Caterpillar

Do not go beneath cab unless cab is empty and support lever is engaged.Failure to follow the instructions or heed the warnings could result in injury or death.
Do not tilt the cab using an open door. The door must be closed and latched when lifting the cab. The door may become dislodged from its hinges and may cause serious personal injury or death.
Tilting the Cab Upward
Park the machine on level ground.Note: Empty the roof-mounted water tank (if equipped) before you tilt the cab.Note: If the machine is equipped with the optional HVAC breather kit, disconnect the ductwork between the cab snorkel, and fresh air filter cover before tilting the cab upward.
Lower the loader arms fully. If you tilt the cab upward with the loader lift arms in the RAISED position, engage the brace for the loader lift arms. See Operation and Maintenance Manual, "Loader Lift Arm Brace Operation" for the process for engaging the brace for the loader lift arms.
Turn the engine start switch key to the OFF position.
Remove the two front bolts for the ROPS. There is one bolt on each side of the cab under the lift arms.
Close the cab door and ensure that the door is latched.
Tilt the cab upward. Stand on the ground when you tilt the cab.Note: More than one person may be needed to tilt the cab.
Illustration 1 g02625112
Cab support lever. For clarity the lift arm is not shown.
(1) Unlocked
(2) Locked
Illustration 2 g02641677
The cab support lever is on the right side of the machine. As the cab raises, the locking lever will slide into the LOCKED position. Ensure that the cab support lever is in the LOCKED position.Tilting the Cab Downward
Note: More than one person may be needed to tilt the cab.
Ensure that no person is under the cab. Remove all the tools and unsecured items that are underneath the cab.
Tilt the cab upward. Move the cab support lever to the UNLOCKED position.
Tilt the cab downward.
Install the bolts for the ROPS. Torque the bolts to 125 10 N m (92 7 lb ft).Note: If the machine is equipped with the optional HVAC breather kit, reconnect the ductwork between the cab snorkel and fresh air filter cover.
Illustration 3 g01271548
Type 1 Cab Mount
(1) Bolt
(2) Washer
(3) Rubber mount - top half
(4) Washer
(5) ROPS structure
(6) Spacer
(7) Rubber mount - bottom half
(8) Washer
(9) Frame
(10) Spacer
(11) Locknut
Illustration 4 g03823772
Type 2 Cab Mount
(1) Bolt
(2) Washer
(3) Rubber Mount - Top Half
(4) ROPS Structure
(5) Rubber Mount - Bottom Half
(6) Washer
(7) Frame
(8) Spacer
(9) Locknut