BRAKE GP-SERVICE & PARKING 2952584 - Caterpillar

Illustration 10 g01144879
Use Tooling (H) to install Duo-Cone seal (16) in to spindle (17). Refer to Disassembly and Assembly, "Duo-Cone Seals - Install". Raise the temperature of bearing cone (15). Install bearing cone (15) to spindle (17).
Illustration 11 g01144877
Lower the temperature of bearing cups (12) and (13). Install bearing cups (12) and (13) to wheel (3). Use Tooling (H) to install Duo-Cone seal (14). Refer to Disassembly and Assembly, "Duo-Cone Seals - Install".
Illustration 12 g01144862
Attach Tooling (C), Tooling (D), Tooling (E), and a suitable lifting device to wheel (3) and position wheel (3). The weight of wheel (3) is approximately 250 kg (550 lb). Use Tooling (D) and Tooling (C) to secure wheel (3).
Illustration 13 g01144854
Position retainers (10) to ring gear (8).
Illustration 14 g01144855
Raise the temperature of bearing cone (11) and install bearing cone (11) onto hub assembly (4).
Illustration 15 g01144849
Attach a suitable lifting device and Tooling (E) to hub assembly (4). The weight of hub assembly (4) is approximately 68 kg (150 lb). Install hub assembly (4) into ring gear (8). Install bolts (9).
Illustration 16 g01144796
Illustration 17 g01144820
Illustration 18 g01144927
Attach a suitable lifting device to hub assembly (4) and position hub assembly (4) and ring gear (8). The combined weight of hub assembly (4) and ring gear (8) is approximately 159 kg (350 lb).
Use Tooling (F) to measure the thickness of retainer (6) at three Locations (X). Average the readings and record the measurement.
Position retainer (6) without shims (7). Install bolts (5) in the numeric sequence that is shown in Illustration 18. Tighten bolts (5) to a torque of 112 18 N m (83 13 lb ft).
Remove Tooling (D) from both sides of wheel (3). Remove the suitable lifting device from hub assembly (4). Rotate wheel (3) for one full revolution.
Loosen bolts (5) slightly. Tighten bolts (5) according to the tightening sequence in Illustration 18. Tighten bolts (5) to a torque of 50 9 N m (37 7 lb ft). Rotate wheel (3) for one full revolution.
Use Tooling (G) to take three measurements at Locations (X). Average the readings and record the measurement.
Subtract the measurement that was recorded in Step 8 from the measurement that was recorded in Step 12. Add 0.10 mm (0.004 inch) to this measurement. Record the measurement. This measurement is the total shim pack thickness that is required.
Use Tooling (G) to measure the thickness of shims (7). The thickness of shims (7) must be within 0.025 mm (0.0010 inch) of the measurement that was recorded in Step 13.
Attach a suitable lifting device to hub assembly (4). Attach Tooling (D), Tooling (C), and Tooling (E) to wheel (3) to secure wheel (3). Remove bolts (5) and retainer (6).
Position shims (7) and retainer (6). Install bolts (5). Tighten bolts (5) to a torque of 530 70 N m (391 52 lb ft).
Illustration 19 g01145739
Attach Tooling (A) and a suitable lifting device to final drive (2) and position final drive (2). The weight of final drive (2) is approximately 136 kg (300 lb).
Install bolts (1).
Repeat Step 1 through Step 18