BRAKE GP-CALIPER 5003134 - Caterpillar

Illustration 7 g02023592
Install backup rings (45) and (44) . Install O-ring seals (43) on cylinder load shuttle valve (36) . Install ball (42) . Lower the temperature of seat (41) . Install seat (41) into cylinder load shuttle valve (36) .
Illustration 8 g02023590
Install backup rings (40) and O-ring seals (39) on cylinder crossover relief valve (35) .
Illustration 9 g02023583
Install backup rings (38) and O-ring seals (37) on pressure regulating valve (34) .
Illustration 10 g02023574
Install pressure regulating valve (34) . Tighten pressure regulating valve (34) to a torque of 60 7 N m (44 5 lb ft).
Install cylinder crossover relief valve (35) . Tighten cylinder crossover relief valve (35) to a torque of 60 7 N m (44 5 lb ft).
Install cylinder load shuttle valve (36) . Tighten cylinder load shuttle valve (36) to a torque of 35 3 N m (26 2 lb ft).
Illustration 11 g02062334
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Lower the temperature of seat (25A) . Install seat (25A) .
Install ball (25) , spring (27) , O-ring seal (29) , spring pin (31) , and plug (33) .
Lower the temperature of seat (24A) . Install seat (24A) .
Install ball (24) , spring (26) , O-ring seal (28) , spring pin (30) , and plug (32) .
Illustration 12 g02023559
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
If retainer assembly (17) was removed from the relief valve, install O-ring seal (15) on retainer assembly (17) .
Install retainer assembly (17) in cap (21) according to the recorded measurement.
Install O-ring seal (20) on cap (21) . Install O-ring seals (12) and (13) on valve group (18) .
Install plate (16) , piston (22) , spring (14) , valve (19) and cap (21) in the relief valve. The torque for cap (21) is 100 10 N m (74 7 lb ft). The torque for nut (23) is 50 7 N m (37 5 lb ft).
Illustration 13 g02062316
Install relief valve (11) . Tighten relief valve (11) to a torque of 100 10 N m (74 7 lb ft).
Illustration 14 g02023556
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install pipe plug (6) , screen assembly (7) , spring (8) , O-ring seal (9) , and plug (10) .
Illustration 15 g02023555
Install O-ring seal (4) and plug (5) to steering control valve (1) .
Illustration 16 g02023553
Install O-ring seal (2) and plug (3) to steering control valve (1) .End By: Install the steering control valve.