BRAKE AS 9R6509 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     -     LOCTITE 5900 Flange Sealant     1    
Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the proper draining and filling procedures.
Illustration 1 g02750905
Remove hose (1) .
Remove tee assembly (2) and the adapter assembly. Remove drain assembly (4) and the O-ring seal.
Remove engine oil level sensor (3) .
Illustration 2 g02750917
Remove hose (5) .
Remove bolts (8) .
Remove bolts (9) for oil pan (10). Use two people to remove oil pan (10). The weight of oil pan (10) is approximately 40 kg (88 lb).Note: Remove and discard the gasket between oil pan (10) and oil pan (7) .
Remove the remaining bolts (9) and remove oil pan (7) .
Remove oil pan (6) from oil pan (7) .
Remove gasket (11) .Installation Procedure
Install engine oil pan (6), oil pan (7), and oil pan (10) in the reverse order of removal.Note: Install the engine oil pans as one assembly for final installation. Use to people to position the oil pan assembly. The approximate weight is 52 kg (115 lb).Note: Make sure that all surfaces are free of containments. Trim excess gasket material from the gasket between oil pan (10) and oil pan (7) .
Illustration 3 g02750956
Apply Tooling (A) to Locations (X) and over the ball and socket joints of gasket (11) .Note: Illustration 3 shows the tightening sequence for bolts (9). The directional arrow is pointing towards the front housing.
Tighten bolts (9) using the above sequence to a torque of 47 9 N m (35 7 lb ft).
Tighten bolts (9) again using the above sequence to a torque of 47 9 N m (35 7 lb ft).
Tighten engine oil level sensor (3) to a torque of 25 1 N m (221 9 lb in).