BREATHER AS 4773762 - Caterpillar

Fabricating the Adapter Harness Assembly
The adapter harness assembly is required for machines with the 4E-0599 Harness . The adapter harness assembly provides power to the electronic shifter.Note: The adapter harness assembly is not required for machines that have been upgraded with the 122-6078 Harness .
Illustration 1 g00567809
Adapter Harness AssemblySee Table 2 and Table 3 for parts and tools needed.
Cut the 5P-5623 Wire (7) into 3 equal lengths. See Illustration 1.Note: Dimension (A) is 150 mm (6.0 inches).
Splice the 3 wires together as shown in Illustration 1.Note: Solder the splice with the 9U-7561 Field Soldering Iron .
Insulate the splice by wrapping the splice with the 1P-0810 Electrical Tape (12) .
Install the 8T-8729 Connector Pin (10) on the end of one wire. This wire is designated as Wire (164A). Use the 1U-5804 Crimp Tool to install connector pin (10) .Note: Refer to Special Instruction, SEHS9615, "Servicing DT Connectors".
Install connector pin (10) in Position 1 of the 102-8802 Receptacle Kit (8) .
Install the 8T-8737 Seal Plug (11) in Position 2 of receptacle (8) .
Install the wedge in order to secure the connector pin in the receptacle.
Install the two