BRUSH 3842557 - Caterpillar

Work Tool Parameter Descriptions
Table 1
Work Tool Parameter Descriptions    
#     Cat ET Name     Monitor Name     Description     Purpose / Explanation    
1     Tool Program Tool Type     "Tool Type"     Type of installing tool     Select image to display on monitor.    
2     Tool Program Name     "Tool Program Name"     Name of installing tool     Set the tool name to display on monitor.    
3     Maximum Throttle Dial     "Max Throttle Dial Position"     Setting of maximum value of engine speed dial     Upper limit value of the engine speed dial becomes the previously set value when the tool was operated.    
4     Minimum Throttle Dial     "Min Throttle Dial Position"     Setting of minimum value of engine speed dial     Lower limit value of the engine speed dial becomes the previously set value while the tool is selected.    
5     Fuel Economy Mode Enable Status     "Eco Mode Enable Status"     Setting of ECO mode     Enabled/Disabled of ECO mode is set.    
6     Initial Tool Program Medium Pressure Circuit Main Pump Power Reduction     Init Med Circuit Torque Red     Setting of initial value of auxiliary pump reduction horsepower function     When auxiliary pump is installed, the ratio of torque reduced on the main pump side when the tool using the auxiliary pump is not being operated is set. (For purpose to prevent overload of the engine)    
7     Total Tool Program Medium Pressure Circuit Main Pump Torque Reduction     Total Med Circuit Trq Red     Setting of overall value of auxiliary pump reduction horsepower function     When the tool using auxiliary pump is operated, the ratio of torque to be reduced on main pump side is set. (For purpose to prevent overload of the engine)    
8     One Way / Two Way Valve Mode     1Way/ 2Way Valve Mode     Flow setting for one or two way flow     One way or two way flow to the work tool is set.    
9     Hydraulic Temperature High Warning Event Threshold     "Overheat Event Threshold"     Setting of temperature to start warning due to increase of hydraulic oil temperature     To indicate the warning on the monitor when the hydraulic oil temperature reached the pre-set value by setting the allowable maximum oil temperature of the installed ATT tool.    
Attachment Valve #1 and #2 parameter settings    
10     Attachment Valve #1 Flow Setting     "Atch #1 Flow Setting"     Setting flow of ATT valve #1     Set appropriate flow for ATT tool to be controlled by operation of ATT valve #1.    
11     Attachment Valve #1 Multi-Oper. Additional Flow     "Atch #1 Multi-Ope Add Flow"     Additional flow of ATT valve #1 in synchronous operation     Set additional flow in case movement is slow when synchronous operation of ATT tool and other movement is performed.
If the additional flow is too much, breakage of ATT tool to be installed could