BRUSH A- 4C3895 - Caterpillar

Illustration 29 g06070774
Illustration 30 g06070781
Illustration 31 g06070814
(U) Rod end plug
(V) Head end plug
Remove the rod end plug (U) and head end plug (V) from the valve.
Illustration 32 g06070826
(31) Clip - ladder
(32) O-ring
(37) Adapter
(38) Sensor
Install an o-ring (32) onto each sensor (38). Install adapter (37) into valve as shown, then install sensor (38). Install remaining sensor (38) into valve. Install clip (31).
Illustration 33 g06070846
(34) Harness
Illustration 34 g06070873
(1) Bolt
(8) Clip
(14) Washer
(34) Harness
(39) Bracket
Install harness (34) as shown using bracket (39), clip (8), bolt (1), and washer (14).
Illustration 35 g06070902
(1) Bolt
(8) Clip
(14) Washer
(34) Harness
(39) Bracket
Install harness (34) as shown using bracket (39), clip (8), bolt (1), and washer (14).
Illustration 36 g06070922
(35) Harness
Illustration 37 g06070930
(27) Strap-cable
(35) Harness
(37) Adapter
(38) Sensor
Install harness (35) as shown using strap-cable (27) every 300 mm (11.8 inch) to secure and one per sensor pigtail. Plug in sensors (38).
Illustration 38 g06070944
(W) Rotary sensor
(27) Strap-cable
(35) Harness
Route harness (35) as shown using strap-cable (27) every 300 mm (11.8 inch) to secure. Unplug connector from rotary sensor (W) and plug in the pass through connectors to the harness (35) and rotary sensor (W).
Illustration 39 g06070955
(36) Harness
Illustration 40 g06070962
(X) Chassis flex joint
(Y) Cab clipping point
(27) Strap-cable
(36) Harness
Route harness (36) as shown using strap-cable (27) every 300 mm (11.8 inch) to secure. Provide extra length in harness (36) between the chassis flex joint (X) and cab clipping point (Y).
Illustration 41 g06070972
(Z) Connector CJ-C13
(36) Harness
Connect three wires from harness (36) to connector CJ-C13 (Z) as follows:
C530-RC1-BU(Blue)- Pin 38
C529-RC2-GY(Grey)- Pin 39
E416-RC3-PU(Purple)- Pin 40Reference Section
For additional information, refer to Publication Operation and Maintenance Manual, SEBU8792, "System Pressure Release" and Specifications, SENR3130, "Torque Specifications".