BRUSH 4F2302 - Caterpillar

Table 1
Required Part
Part Number Part Name
563-4563 Monitor Software Gp Note: This software requires a software support date on the CB460 Control Box of 12 December 2016or later. In case the software support date on the CB460 Control Box does not support this release, it will be necessary to update the software support agreement through SITECH. If the CB460 Control Box is already loaded with v13.10 or later software, v13.13 is also supported by the same software support date.Note: Refer to Special Instruction , M0080930 for guidance and the steps required to update the Control Box. The special instruction also lists the Operating System (OS) files required for v13.13 OS 516-0908 Monitor Software Gp which are the same as the OS required for v13.10.The new software has various improvements and features that are listed below:Applies to all machine models
Updated to support the radios to select "Rest of World" option and eliminates selecting a different region to the one chosen.
Addressed to eliminate some text in the control box still appearing in English even when the language selected was Japanese.
Updated to display the "Cell Strength" icon properly on the control box, when the SNM940 is in AP mode.
Updated to display "Out of Range" warning message, when the machine is out of working range of the closest Universal Total Station (UTS).
Updated to disappear the "Off Design" warning message, after the machine comes back onto the design.
Addressed to eliminate additional vertical guidance point appearing on the blade in the guidance view, when the configured vertical guidance method specifies one point guidance.
Updated to include version 5.21 of Global Navigation Satellite System (GNSS) receiver firmware bundled with the CB460 software.
Added support to the use of Zephyr 3 Rugged antenna usage on Cat Grade Control systems.Applies only to Excavators
Updated to support "Tilt Assist" usage along with a 3D system and to address where the tilt function would not drive to grade.
Addressed to eliminate "Grade Assist" would not cut to grade with negative offsets.Applies only to Track Type Tractors
Updated to support Cat Grade Control 3D system in Autos, where the system produced a poor graded surface finish due to a harsh blade-chop on steeper mainfall slopes.
Updated to support blade mount AccuGrade on the Cat Grade Control 3D system, where the name entered in the Machine Settings dialog was overwritten with the default machine name from the Electronic Control Module (ECM).Applies only to Asphalt/Soil/Landfill Compactors
Addressed to eliminate incorrect Cold Cranking Amps (CCA) values were written to the tag files.
Updated support for synchronizing the target Machine Drive Power (MDP) between the CB460 control box and the machine display.
Addressed to eliminate the system mapped passes when the auto mapping rules were set to "Vibration OFF".
Updated to write vibration data to tag files.Note: The automatic ground mapping condition "Driving forward" only applies to the on-screen maps. Log files ("*.tag") are recorded whenever the machine is moving, even when reversing. Solution: Filter the tag files in VisionLink for when the machine is only driving forwards.Note: Mapping data from previous versions of