BUCKET AS-EXCAVATION 1982762 - Caterpillar

Table 1
Parts that are required for the PS-300B machines    
Item     Quantity     Part Number     Description    
1     1     178-4784     Protector Assembly    
1 178-4785     Protector Assembly    
2     2     8T-3612     Weld Nut    
3     60 CM     104-6067     Seal    
4     8     8T-4198     Bolt    
8 8T-4224     Hard Washer    
2 8T-4136     Bolt    
4 8T-4133     Nut    
2 8T-4121     Hard Washer    
Table 2
Parts that are required for the PF-300B machines    
Item     Quantity     Part Number     Description    
1     1     178-4788     Protector Assembly    
1 178-4789     Protector Assembly    
2     2     8T-3612     Weld Nut    
3     60 CM     104-6067     Seal    
4     8     8T-4198     Bolt    
8 8T-4224     Hard Washer    
2 8T-4136     Bolt    
4 8T-4133     Nut    
2 8T-4121     Hard Washer    
Remove the existing protectors for the brakes from the machine.
You may be required to relocate one of the weld nuts on housing (A) in order to adapt the new protectors for the brakes so that the protectors fit on some of the old machines.
Illustration 1 g00777419
Use the new protector as a guide. Hold the new protector (1) against the existing housing (A) .
Make sure that the mounting holes on the new protector line up with the existing holes in the housing. If the holes do not line up, refer to illustration 2 in order to relocate one of the holes in housing (A) .
Illustration 2 g00777492
Housing (A) may require a new hole. Attach weld nut (2) .
Refer to illustration 1 to cut seal (3) and attach seal (3) on the protector. Perform this operation before the protector is attached to the machine.
Use hardware (4) to attach protector (1) to housing (A) .
Repeat the process for the other side of the machine.