BUCKET AR-LIGHT MATERIAL 2611391 - Caterpillar

Do not use threaded rods that have not been hardened as tooling with hydraulic cylinders. The maximum rated tonnage should be stamped on one end of the puller studs. Do not use threaded rods that have not been stamped with the rated tonnage.
Start the engine. Park the machine on a hard, level surface. Fully extend the stick. Position the bucket level on the ground. Shut off the engine.
Release hydraulic system pressure.
Illustration 1 g02144874
Slide O-ring seals (3) off the pin joints between the bucket and the power link and onto the flanges of the bucket.
Remove bolt (2). Attach Tooling (A) to pin assembly (1). Attach a suitable lifting device and Tooling (B) to Tooling (A). The weight of Tooling (A) is approximately 137 kg (300 lb). Note: Reposition the suitable lifting device during the removal of pin assembly (1).
Use Tooling (A) in order to remove pin assembly (1). The combined weight of Tooling (A) and pin assembly (1) is approximately 170 kg (375 lb).
Remove O-ring seals (3) from the flanges of the bucket.
Illustration 2 g02144875
Illustration 3 g02144876
Start the engine. Extend the bucket cylinder. Use a suitable blocking in order to support the bucket cylinder. Use a suitable blocking in order to support the link assemblies. Shut off the engine.
Attach a suitable lifting device and Tooling (B) to power link (6). The weight of power link (6) is approximately 159 kg (350 lb). Raise power link (6) to a horizontal position.
Remove nuts (5) and bolt (4) from pin (7).
Attach Tooling (C) to pin (7). Attach a suitable lifting device and Tooling (B) to Tooling (C). The weight of Tooling (C) is approximately 66 kg (145 lb).
Use Tooling (C) in order to remove pin (7). The combined weight of Tooling (C) and pin (7) is approximately 100 kg (220 lb). Remove pin (7), the shims, and power link (6).
Illustration 4 g02144877
Illustration 5 g02144878
Attach a suitable lifting device to link assembly (8). The weight of link assembly (8) is approximately 39 kg (85 lb). Remove nuts (9) and bolt (10).
Remove the grease fitting from pin (11). Attach Tooling (D) to pin (11). Attach a suitable lifting device and Tooling (B) to Tooling (D). The weight of Tooling (D) is approximately 34 kg (75 lb).
Use Tooling (D) to partially remove pin (11) in order to remove link assembly (8).
The combined weight of pin (11) and Tooling (D) is approximately 50 kg (110 lb).
Attach a suitable lifting device to link (12). The weight of link (12) is approximately 32 kg (70 lb).
Use Tooling (D) to remove pin (11) and link (12). Installation Procedure
Install the bucket linkage in the reverse order of removal.
Illustration 6 g02145227
Use Tooling (E) in order to install pin (11).
Illustration 7 g02145291
Install outer nut (9) on bolt (10). Dimension (X) is 0.5