BUCKET AS-GENERAL PURPOSE 2929270 - Caterpillar

1. Remove handle (1) from the rod.2. Remove screws (2) and remove bracket assembly (3) from the housing. 3. Disconnect wire (4) and remove bracket assembly (3) from the cab. 4. Remove pin (5) and lever (6) from the pin. 5. Remove cotter pin (7) from pin (8). 6. Remove pin (8), plate assembly (11) and spring (10) from the bracket assembly.7. If necessary remove switch (9) from the bracket assembly. 8. Remove bearing (12) from the bracket assembly. 9. Remove the bolt and disconnect cable (13) from the transmission selector control.10. Remove the two bolts that hold yokes (14) to the housing. Remove the transmission selector control from the machine. 11. Remove the cotter pins, pins (16) and yokes (14) from the lever assembly.12. Remove the screws and magnets (15) from the lever assembly. 13. Remove bearings (17) from yokes (14). 14. Remove spring (21) from lever assemblies (19) and (22).15. Remove the cotter pins, pins (20) and make a separation of yokes (18) from lever assembly (22). 16. Remove rod (24) from lever assembly (22).17. Remove bushings (23) from lever assembly (22). 18. Remove the bolts and yokes (18) from lever assembly (19).19. Remove bushings (25) from lever assembly (19). 20. Remove bushings (26) from yokes (18).Install Transmission Selector Control
1. Use tool group (A) and install bushings (2) in yokes (1) so that the bushings are 9.3 0.3 mm (.366 .012 in.) apart as shown. 2. Use tool group (A) and install bushings (4) in lever assembly (3) 0.4 0.2 mm (.020 .008 in.) above outside surfaces (X).3. Install yokes (1) in lever assembly (3). 4. Use tool group (A) and install bushings (7) in lever assembly (5) 0.4 0.2 mm (.020 .008 in.) above outside surfaces (Y).5. Install rod (6) in lever assembly (5). 6. Put yokes (1) in position on lever assembly (5). Install pins (8) and the cotter pins that hold lever assembly (3) to lever assembly (5).7. Install spring (9) on lever assemblies (3) and (5). 8. Use tool group (A) and install bushings (11) in yokes (10) so that the bushings are 9.3 mm 0.3 mm (0.366 0.01 in.) apart as shown. 9. Install magnets (12) on the lever assembly.10. Install yokes (10) on the lever assembly with the pins and the cotter pins. 11. Install yokes (10) to the housing that hold the transmission selector control in position.12. Connect cable (13) to the transmission selector control. 13. Use tool group (A) and install bearing (15) in bracket assembly (14). 14. Install switch (18) on bracket assembly (14).15. Install pin (19), plate assembly (16) and spring (17) on bracket assembly (14). 16. Install cotter pin (20) to hold the pin in place in the bracket assembly. 17. Install lever (22) on the pin with pin (21) that holds it in place. 18. Connect wire (23). 19. Put bracket assembly (14) in position on the housing with the screws that hold it.20. Install handle