BUCKET GP-HOE 3031328 - Caterpillar

1. Fasten a hoist to seat (1) and release latch (2) that holds the seat. Remove the seat. Weight of the seat is 60 lb. (27 kg). 2. Remove the cover from over the batteries. Disconnect battery cables (3), (4) and (7). Remove nuts (6) and rods (8). Remove bracket (5) that holds the batteries to the fender. Remove the batteries with a hoist. Weight of each battery is 160 lb. (73 kg).3. Remove the floor plates.4. Remove the bolts that hold the cover for the hydraulic controls (if so equipped). 5. Remove plate (11), boot, cover (9) and cushion (10) (if so equipped).6. Disconnect the two cables (12) from the disconnect switch. Put identification on the cables to prevent mixing at assembly. 7. Remove the nut from over the selector control lever. Remove the selector control lever with tooling (A).8. Disconnect rod (13) at the parking brake lever. 9. Remove six bolts (14) that hold the seat frame assembly to the side panel for the hydraulic controls and the support for the seat frame assembly.10. Remove three bolts (15) that hold the directional control lever in position. Remove the three bolts that hold the seat frame assembly to the left fender of the machine. 11. Fasten a hoist to the seat frame assembly (16). Remove the seat frame assembly. Weight of the seat frame assembly is 155 lb. (70 kg).
Do not cause damage to the battery cables when the seat frame assembly is removed.
Install Seat And Seat Frame Assembly
1. Fasten a hoist to the seat frame assembly. Put the seat frame assembly in position on the machine. Install three bolts (1) that hold the seat frame assembly to the fender. Install the six bolts that hold the seat frame assembly to the side panel for the hydraulic controls.2. Put the two battery cables (2) through the holes in the side of the seat frame assembly.3. Put the directional control lever in position on the side panel for the hydraulic controls. Install the three bolts that hold it.4. Connect the rod to the parking brake lever. 5. Install selector control lever (3). Install the nut (4) that holds it.6. Connect the two battery cables to the disconnect switch. 7. Install the cushion on the seat frame assembly. Install cover (5). Install the bolts that hold it. Install the boot and plate over the hydraulic control lever.8. Install the floor plates.9. Put the batteries in the correct position on the fender of the machine. Install the bracket and rods that hold the batteries in position.10. Connect the three battery cables to the batteries. 11. Install cover (6).12. Fasten a hoist to the seat. Put the seat in position on the seat frame assembly. Connect the latch that holds the seat in position.